It is very simple and economical to do, and in this article we will show you how to make it.
We'll need a tube of Sponge Rez, a glue specially designed to fix bodyboards, and a sticker. With the Sponge Rez, we'll seal the gap, so that water can't get inside the board. For this, it's important that your board is clean and dry. Thoroughly remove all traces of paraffin, sand, or any type of dirt. Apply the Sponge Rez to the area to be repaired, you can use a plastic card or a piece of cardboard to spread the Sponge Rez and smooth it out.
It is very simple and economical to do, and in this article we will show you how to make it.
After a fifteen minutes, you will see how the sponge rez begins to harden, after 2 hours you will see it completely hard, but it is necessary to wait 24 hours so that it is 100% hard. You will see how it forms an elastic layer, which holds well the deformations of our body boards.
Apply a sticker on the repaired area, not only for aesthetics, but also to protect the repair, and prevent the sponge rez from taking off.
That´s it, your bodyboard is ready to go back to the water. It's easy and quick, but it's important to do it to extend the life of your bodyboard. And as a good video is worth more than 1000 words, we have prepared a small demonstration in images:
Products you may be interested in:
